Make sure your paper lines up with the marks on the cutting mat. You must use a cutting mat when doing a Print & Cut project. Marks that go off the page will unfortunately not be read by the Silhouette Cameo®. ![]() Print your document.Īgain, making sure all your registration marks have been fully printed. Again, if they are outside the print border, you may adjust them by increasing or decreasing the position of the insets on the Position option on the Registration Marks panel. You want them contained in the print border for them to all be printed! Partial or incomplete registration marks will not be detected by Silhouette Studio ®. To have all your registration marks printed, be mindful of where they are when setting them up. Position them inside the area without the hash marks for it to be cut. I used the Diamond cut file from designer Loni Harris ( Design ID #16190) and converted the design into a tag I can use later on. The default sizes will give you a smaller area than the print paper to work with-you can adjust this by lowering the number on the Position options on the Registration Marks panel. Whatever paper type you are using, you must always ensure that the actual paper size you will be using matches the page size on screen so your cut lines will line up perfectly with the printed portion of your Print & Cut.ĭon’t forget to check “Show Print Border” so you can see where your printer will actually print-again, printers cannot print past this print border. You can also use a wide format printer, but bear in mind the width of the Silhouette Cameo ® is 12 inches maximum, so make sure to design your graphics only as wide as 12 inches. Most printers have a default size of 8.5″ in. Make sure to set your paper size to “Current printer.” ![]() Setting Up Your Design And Adding Registration Marks In Silhouette Studio® 1.
0 Comments
Leave a Reply. |